I cannot add a monitoring method for my chemical treatment
Print
Modified on: Thu, 12 May, 2022 at 8:17 AM
- This is most likely happening because the chemical treatment component was not listed as a control location. If you want to edit the controls for a component, you must list the component as a control location.
- In your LegiMapper diagram find the chemical treatment component. Click the hamburger menu and then click Edit.
- Select Yes for the question "Is this component a control location?". Click Save.
- Go to LegiDoc Process Flow Diagrams section and proceed to import your recently changed diagram.
- Go to Step 2 Enter data and find the water system that contains the chemical treatment in the left-hand navigation menu. Then go to the Control Limits Monitoring section. Click Edit, add your own monitoring method, and a reason for the frequency and method change.
- Alternatively, if you have manually created your water system components in LegiDoc, go to Step 1 Setup under the Water System Components section.
- Find the chemical treatment component. Click the ellipses and then click Edit.
- Select Yes for the question "Is this component a control location?". Click Save.
Did you find it helpful?
Yes
No
Send feedback Sorry we couldn't be helpful. Help us improve this article with your feedback.
